Wireless-New
| Line 24: | Line 24: | ||
| PDAP-9|| 10.2.1.9 || || | | PDAP-9|| 10.2.1.9 || || | ||
|- | |- | ||
| PDAP-10|| 10.2.1.10 || | | PDAP-10|| 10.2.1.10 || Navarr woods || | ||
|- | |- | ||
| PDAP-11|| 10.2.1.11 || || | | PDAP-11|| 10.2.1.11 || || | ||
| Line 85: | Line 85: | ||
| bridge-c || 10.1.0.16 || 0017.e009.5f50 || 10.1.0.15 || 10.2.0.16 || || repeater || || || - | | bridge-c || 10.1.0.16 || 0017.e009.5f50 || 10.1.0.15 || 10.2.0.16 || || repeater || || || - | ||
|- | |- | ||
| bridge-d || 10.1.0.18 || 0017.94a6.9b00 || 10.1.0.17 || 10.2.0.18 || || root bridge wireless-clients || || OK || - | | bridge-d || 10.1.0.18 || 0017.94a6.9b00 || 10.1.0.17 || 10.2.0.18 || || root bridge wireless-clients || GOD -> Navarr woods || OK || - | ||
|- | |- | ||
| bridge-e || 10.1.0.40 || 001f.9ed3.3fe0 || 10.1.0.41 || 10.2.0.40 || || non-root bridge wireless-clients || || || - | | bridge-e || 10.1.0.40 || 001f.9ed3.3fe0 || 10.1.0.41 || 10.2.0.40 || || non-root bridge wireless-clients || || || - | ||
Revision as of 11:52, 22 April 2022
Configuration
| Cisco 1600 | |||
|---|---|---|---|
| Hostname | BVI IP | Location | Notes |
| PDAP-1 | 10.2.1.1 | ||
| PDAP-2 | 10.2.1.2 | ||
| PDAP-3 | 10.2.1.3 | ||
| PDAP-4 | 10.2.1.4 | ||
| PDAP-5 | 10.2.1.5 | ||
| PDAP-6 | 10.2.1.6 | ||
| PDAP-7 | 10.2.1.7 | ||
| PDAP-8 | 10.2.1.8 | ||
| PDAP-9 | 10.2.1.9 | ||
| PDAP-10 | 10.2.1.10 | Navarr woods | |
| PDAP-11 | 10.2.1.11 | ||
| PDAP-12 | 10.2.1.12 | ||
| PDAP-13 | 10.2.1.13 | ||
| PDAP-14 | 10.2.1.14 | ||
| PDAP-15 | 10.2.1.15 | ||
| PDAP-16 | 10.2.1.16 | ||
| PDAP-17 | 10.2.1.17 | GOD | |
| PDAP-18 | 10.2.1.18 | ||
| PDAP-19 | 10.2.1.19 | ||
| PDAP-20 | 10.2.1.20 |
| Cisco 702W | |||
|---|---|---|---|
| Hostname | BVI IP | Location | Notes |
| PDAP-30 | 10.2.1.30 | ||
| PDAP-31 | 10.2.1.31 | ||
| PDAP-32 | 10.2.1.32 | ||
| PDAP-33 | 10.2.1.33 | ||
| PDAP-34 | 10.2.1.34 | ||
| PDAP-35 | 10.2.1.35 | ||
| PDAP-36 | 10.2.1.36 | ||
| PDAP-37 | 10.2.1.37 | ||
| PDAP-38 | 10.2.1.38 | ||
| PDAP-39 | 10.2.1.39 |
| Cisco 1300 | |||||||||
|---|---|---|---|---|---|---|---|---|---|
| Hostname | Wireless IP | Wireless MAC | FastEthernet IP | BVI IP | Channel | Mode | Location | Config Status | Notes |
| bridge-a | 10.1.0.2 | 0026.cb6a.8db0 | 10.1.0.1 | 10.2.0.1 | 2412 | non-root bridge wireless-clients | Navar | - | |
| bridge-b | 10.1.0.4 | 0023.5e0b.6b40 | 10.1.0.3 | 10.2.0.4 | 2437 | root access point | - | ||
| bridge-c | 10.1.0.16 | 0017.e009.5f50 | 10.1.0.15 | 10.2.0.16 | repeater | - | |||
| bridge-d | 10.1.0.18 | 0017.94a6.9b00 | 10.1.0.17 | 10.2.0.18 | root bridge wireless-clients | GOD -> Navarr woods | OK | - | |
| bridge-e | 10.1.0.40 | 001f.9ed3.3fe0 | 10.1.0.41 | 10.2.0.40 | non-root bridge wireless-clients | - | |||
| bridge-f | 10.1.0.42 | 0013.19a4.9fe0 | 10.1.0.43 | 10.2.0.42 | root access point | - |
Configuring 1600
PDCREW and PD_PUBLIC on the 2.4GHz radio, PD_BACK on 5GHz for mesh
- Process, copy the config below, edit it to replace the AP name and BVI address to match. Set the passwords
- Connect to the AP via the console port
- `enable` to get control
- `write erase` to clear the existing config
- `reload` confirm when promted. You do not want to copy any changes if asked
- when the AP has restarted, once again `enable`
- `conf t` to enter config mode
- paste in your config
- `write mem` to save the config
- wait for about a minute you should see chatter about the radio doing things
hostname PDAP-18 ! ! ! dot11 syslog dot11 vlan-name BACKHAUL vlan 1 dot11 vlan-name CREW vlan 12 dot11 vlan-name PUBLIC vlan 13 ! dot11 ssid PDCREW vlan 12 authentication open authentication key-management wpa mbssid guest-mode wpa-psk ascii ***** ! dot11 ssid PD_BACK authentication open authentication key-management wpa infrastructure-ssid wpa-psk ascii ***** ! dot11 ssid PD_PUBLIC vlan 13 authentication open mbssid guest-mode ! ! dot11 network-map dot11 guest ! ! bridge irb ! ! ! interface Dot11Radio0 no ip address ! encryption vlan 1 mode ciphers tkip ! encryption vlan 12 mode ciphers tkip ! ssid PDCREW ! ssid PD_PUBLIC ! mbssid world-mode dot11d country-code GB outdoor speed range power local maximum station-role root access-point ! interface Dot11Radio0.1 encapsulation dot1Q 1 native bridge-group 1 bridge-group 1 subscriber-loop-control bridge-group 1 spanning-disabled bridge-group 1 block-unknown-source no bridge-group 1 source-learning no bridge-group 1 unicast-flooding ! interface Dot11Radio0.12 encapsulation dot1Q 12 bridge-group 1 bridge-group 1 subscriber-loop-control bridge-group 1 spanning-disabled bridge-group 1 block-unknown-source no bridge-group 1 source-learning no bridge-group 1 unicast-flooding ! interface Dot11Radio0.13 encapsulation dot1Q 13 bridge-group 1 bridge-group 1 subscriber-loop-control bridge-group 1 spanning-disabled bridge-group 1 block-unknown-source no bridge-group 1 source-learning no bridge-group 1 unicast-flooding ! interface Dot11Radio1 no ip address ! encryption mode ciphers tkip ! ssid PD_BACK ! world-mode dot11d country-code GB outdoor speed range power local maximum station-role root access-point fallback repeater bridge-group 1 bridge-group 1 subscriber-loop-control bridge-group 1 block-unknown-source no bridge-group 1 source-learning no bridge-group 1 unicast-flooding ! interface GigabitEthernet0 no ip address no ip route-cache duplex auto speed auto bridge-group 1 bridge-group 1 spanning-disabled no bridge-group 1 source-learning ! interface BVI1 ip address 10.2.1.18 255.0.0.0 no ip route-cache ! bridge 1 protocol ieee bridge 1 route ip ! interface dot11Radio 0 no shut interface dot11Radio 1 no shut interface BVI 1 no shut interface GigabitEthernet0 no shut end
Config file 702
Dot11 ssid PDCREW authentication open authentication key-management wpa wpa-psk ascii ****** Guest-mode Exit Int dot11 0 world-mode dot11d country-code GB outdoor speed range power local maximum encryption mode ciphers tkip dot11 extension aironet ssid PDCREW Stat root access No shut Exit Int dot11 1 world-mode dot11d country-code GB outdoor speed range power local maximum encryption mode ciphers tkip dot11 extension aironet ssid PDCREW station-role root access-point No shut exit